Chip-Tools

ITDEENBGES

ABPROG ZN030: EEPROM, NEC, MC9S12, V850 and EWS3 adapters for in-circuit reading and writing

The ABPROG (ZN030 set) is the Abrites programmer for memories and microcontrollers: with its adapters it reads and writes EEPROMs, BCMs, NEC, MC9S12, V850/V850ES/V850E2 and the BMW EWS3. You use it when the data cannot be reached over OBDII and you have to go to the chip.

Procedure

1. Connect the ABPROG (ZN030) to the AVDI; if you need more reach use the CB101 - AVDI extension cable for ABPROG (ZN030).
2. To read and write EEPROMs and BCMs in-circuit, fit the ZN031 - ABPROG EEPROM/BCM adapter.
3. If the chip is desoldered or has to be read off the board, use the ZN035 - ABPROG EEPROM socket.
4. If the wires of the EEPROM/BCM adapter do not reach the soldering point, use the ZN057 - EEPROM wire extender for ABPROG EEPROM/BCM adapter.
5. For NEC microcontrollers choose between the ZN033 - ABPROG NEC adapter (direct connection) and the ZN032 - ABPROG NEC adapter with socket (desoldered chip).
6. For PCF transponders and memories use the ZN046 - PCF for ABPROG.
7. For the BMW EWS3 use the ZN055 - ABPROG EWS3 adapter, powered by the ZN062 - 12V/0.5A DC power adapter; this combination is the one intended for special function VN006.
8. For V850 micros pick the right adapter: ZN078 - V850ES adapter for ABPROG or ZN058 - V850E2 adapter for ABPROG.
9. For Freescale/NXP MC9S12 use the ZN086 - MC9S12 adapter for ABPROG.
10. With the connection checked, open the Abrites software, select the chip type matching the adapter you fitted and run "Read"; always save the original dump before any "Write".

Reference screenshots